Friday, February 29, 2008

As I see it, this just may be what I would term an 'arsenal' rifle, as it
appears quite hasty yet competent. Possibly it was stocked out of parts ca.
1777-1779 while Allentown was crowded with Philadelphia evacuees and a state
arsenal, or gun repair/fabrication facility, was organized there. It
appears petite in some ways but in reality is a big, wide gun. The
buttplate is certainly cut-down from a fowler butt and has a plugged
screwhole at the rear, so it seems reused and installed quickly at something
of an awkward angle. Lock - which obviously uses a replaced cock and
frizzen - looks like an earlier German lock and the sideplate has been
cut-down from a larger and earlier sideplate. It too was reused as the tail
looks cut-off, the rear lock nail hole is filed out very large to
accommodate movement and the nose is chopped. There is still a hint of the
original screw hole in front of the forward lock nail! The set triggers
seem original but at some point the gun must have had another triggerguard
installed as there are remnants of a different mortise fore and aft. And,
this guard itself seems like a secondary piece as the rear finial was broken
and has been riveted back together. Also all that sheet brass - the wear
plate and funky liberty head inlay - are later additions to cover a worn
through forearm (it's worn through right into the rammer channel). Also the
wraparound nosecap was at some point removed and reinstalled but not quite
in the same place - it's moved back a little. I don't know why. Maybe the
rivets accidentally pulled. I don't know who "HR" was but obviously an
owner. There is a VERY faint remnant of a signature on the barrel but it is
impossible to make out. It appears to have been in script as some of the
tails of the letters drop down over the edge of the top flat. Barrel is
rifled, about 44 inches long and .54 caliber. Also you can see where at
some point the toe got whacked and a piece sheared-off; it was glued and
screwed back in plate and the buttplate straightened back out (there's a
little crack there on the buttplate). Heel appears worn through and is now
filled with lead. the set trigger adjustment screw is missing.

The buttplate is almost 2 full inches wide and the wrist is REALLY wide,
like maybe 1 5/8" wide but only something like 1 1/4" tall under the guard.
There seems to be some dishing there like on the later Moll/Rupp/Neihart
rifles but because it's a straight stock there is no step although the lower
butt molding abruptly terminates like it was a step wrist. There is
curvature - a small amount - to the toe line. I really think this thing has
Neihart written all over it but the signature, what little I can make out of
it, does not appear as Neihart's big block letters. It obviously has some
association with Northampton Co. and in particular the Allentown/Whitehall
area. Carving was all raised but is now worn almost flat. The tang carving
and what is left of the carving around the entry pipe - and there isn't much
left there, between wear and the brass plate - looks different from 'the
usual.' The lock and triggers still work, and WELL, can you believe it?!!!
It's certainly a different and exciting rifle. Beautiful cherry stock, deep

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.